TiltBridge Hardware

The first step in a TiltBridge installation is sourcing the necessary hardware. The only component required for a TiltBridge is an ESP32-based board - however selecting the LOLIN D32 Pro and adding the compatible TFT screen will result in the best experience with the most features.


While this page documents hardware that has ben demonstrated to work with TiltBridge in the past, the author of TiltBridge does not warrant that any of the hardware listed below continues to be operational. Additionally, although links to vendors are provided to show examples of the referenced hardware, no guarantees are made as to the vendors themselves. Buy hardware you trust from a vendor you trust.


The recommended board for this project is the LOLIN D32 Pro, along with its TFT screen and cable. This set of hardware enables the full suite of TiltBridge functionality without needing to solder anything. Simply add an enclosure and you’re done!


Although the only required component is the board, you will likely also want the TFT screen & cable:


For the board, you need one of the 16MB variants. Preference should go to the non-LED models.

Additional Hardware Required

In addition to the ESP32 board, you will also need a USB power source to power the ESP32 (such as a phone charger), a MicroUSB cable for flashing, and you will likely want some kind of enclosure (see below).

Once you have acquired the necessary hardware, you are ready to begin Initial Setup


Although not required, an enclosure is recommended. There are a number of designs out there depending on the board you choose.

Notes about Previous Versions/Other Hardware

TiltBridge is designed to run either with or without an attached screen, and therefore can be used with a variety of other boards. Although this functionality exists, due to the myriad issues experienced with OLED boards, non-LOLIN boards, etc. the use of boards other than the LOLIN D32 Pro are not currently recommended for new builds.

If you use another board, make sure to select the appropriate firmware:

  • “OLED” boards, those with less than 16MB of flash, and those lacking a screen entirely should select the “OLED” firmware variant
  • Any non-“OLED” board with 16MB of flash or greater using an attached ILI9341-driven TFT should select the “TFT” firmware variant